si_kungs

we use 12 volts regulated power supply but the output when measured is 13.8V . will there be a problem with this? will the camera be busted easily?

ah i see. thanks. sir survtech are your familiar with vicon system? what protocol for speed dome do they support?

sir for ground loop isolator where do i connect it? at the end of the cable entering the dvr? or at camera?

i have a client who is looking for a speed dome with gold tint that can be connected with vicon system. what speed dome can you recommend. i'm not familiar with vicon

if you were unable to connect. did you try clicking the search button on the video server? it will show you the connected device on your network. it is located beside the address box. also can you connect to the dvr from the internet?

thats why i get humbars. is cable also the problem?

yes you need to look for a local distributor to fix this.

thank you sir

thank you sir survtech. what would be the picture degradation be? it will become blur?

sir do you have a formula how to compute it? so i can decide whether to add additional pair to the power.

for gauge 24. how long can you run 12V power? also, running 220V can it interfere with the video signal?

please contact supplier for instruction of how to do hardware reset. this will set the username and password to default.

is it safe to use the same wire guage of speaker wire to run 12Volts power for cameras?

how long can we run catv coaxial cable for cctv use without having any picture quality loss?

sir what do you mean by lock up every three days? hang up?

yes what you did is to manually move the clock. maybe the crystal oscillator running the clock is not functioning anymore

Hi thanks for the reply,

 

After i installed the card i put in cd disc & clicked on setup.exe for server software. Do i have to install a driver before this.

sir you have to install the driver first before installing the software.

please set the port forwarding feature of the router . you need to specify what port and what address will it direct the connection in case the port was accessed.

have you installed the driver of the card? or just the server software?

sir remo it is the version of the video server (1.0.6.6) . please check the version of the DVR on ADVANCE>>SYSTEM

for canada? what certification is needed?

very nice. can enjoy the view from all angles. this can be used for virtual tour of a certain destination.

You are going to have to take it back from where you bought it under warranty.

 

This is more than just a simple fix.

 

Where did you buy it from??

sir scorpion is right bring it back if under warranty. if it is not under warranty anymore. you can try to upgrade the firmware of the dvr.

please check your record setting. if you set it to overwrite. when your hard disk is full. the dvr will clear 3GB of space. so you will see 3G on the upper right corner. is there an -OW- below the HDD capacity? if there is it is in overwrite function. you cannot stop the recording since you have set the record to manual. if you disabled it. you can manually record and stop.

try to do the hardware reset and see what happens.

Hardware Reset_AVC760_AVC761.rar