Jump to content

Search the Community

Showing results for tags 'onyx settings'.


More search options

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


IP Camera Forums

  • Welcome
    • Introductions
  • IP Systems
    • IP/Megapixel Cameras and Software Solutions
    • HD Analog
  • Digital Video Systems
    • General Digital Discussion
    • DVR Cards and Software - PC Based Systems
    • Computers/Networking
    • Digital Video Recorders
    • Dashcams - Mobile DVR's
  • Video Surveillance Systems
    • System Design
    • Security Cameras
    • Installation Help and Accessories
    • Video Transmission/Control Devices
  • Analog Video Systems
    • General Analog CCTV Discussion
  • Access Control Systems
    • General Access Control Discussion
  • Other Forums
    • Test Bench
    • Questions about this site
    • Trade Shows & Conferences
    • Classifieds

Calendars

There are no results to display.

There are no results to display.

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Joined

  • Start

    End

Group

WEBSITE

FACEBOOK

SKYPE

TWITTER

YOUTUBE

Found 1 result

  1. Apuzzledman
    Hello,I have recently upgraded(I hope) from an AHD system to a 25 channel(12 ip) Onyx NVR with an 8TB hard drive. I have purchased 11 new IP 4K 8mp cameras of around £100 and £135 each from the same company.The cameras are now fitted externally and connected with cat6a external cables into the ports at the back of the NVR.The NVR is wired directly into my hub.After my wife has spent hours on the phone with the company who we purchased it from, the system was meant to record 24hours a day and show through a monitor. Have defog mode set to on with Motion sensor alarm alerts, which are meant to be sent to email address and also we are meant to be able to view through Bitvision on our mobiles or ipad.Please see issues I am having listed below.1,Various (4) cameras are going completely blank and staying off. If I switch the system off and then back on 3 cameras remain off then after approximately half an hour another camera will switch completely off.2,My alerts are very hit and miss some times the alerts are very good, other times no alerts for hours even though cars and people have passed the cameras. then there are times where my alerts are coming through 20 minutes after the event.Please can anyone advise me on what could be the problems? I purchased the system a month ago and am at a loss because the technical guys where I purchased the setup are going around in circles with me.Am I asking too much of the system or should this be fairly straight forward ? either way my system is definitely far from a plug everything in and start straight away system.Any help and advise will be greatly appreciated.Many ThanksApuzzledman We have diagnosed that my system has plenty of POE allowance left so it’s not that(allowances of 200 and with 6 cams saying connected it has 170 remaining. The other thing is that after about 36 hours of completely cutting out, one of the big motorised cameras has now just come on without any reboot or beep from the Nvr ?
×