JoeyJoey 0 Posted May 31, 2013 I have my outdoor camera where WDR is enabled, the noise reduction is set to 100. You can disable motion detection during the night. Reduce the number of active motion squares on the grid to a minimum. I would verify to make sure that you don't have soft video At night, yep, but not in the day time. Share this post Link to post Share on other sites
JoeyJoey 0 Posted June 13, 2013 I updated one camera to version 5.0 Hikvision firmware. There is a new option in the software called "Enabled dynamic analysis for motion" It is shown in the v5.0 manual but not explained. Anyone played with this setting yet? Share this post Link to post Share on other sites
SB_Jim 1 Posted June 14, 2013 Joey, Was that to a Hik (Swann-LOREX) dome? Was it just a toggle on/ off, or was there also a slider? That may be very cool! Share this post Link to post Share on other sites
JoeyJoey 0 Posted June 14, 2013 Just a check box, the Lorex version of the Hikvision DS-2CD2032-I See V5 manual here: http://www.hikvision.su/ndl.php?f=sites/default/files/Hikvision_Network_Camera_User_Manual.pdf I 'think' it changes the red grid colour to green when motion is detected, not sure, just a guess. Share this post Link to post Share on other sites
SB_Jim 1 Posted June 14, 2013 Well, if that's all it did, "yawn"! I was hoping for some pseudo- analytical that might improve on false motion. Share this post Link to post Share on other sites
JoeyJoey 0 Posted June 14, 2013 That is what I was hoping too! I will let you know what I find. As this is only in the camera and not the NVR, it won't mean much either way. Share this post Link to post Share on other sites
JoeyJoey 0 Posted June 14, 2013 yep, that is what it is, the green boxes to help you tune the motion area. It at least lets you know that the motion is being detected, it'd be nice if this was in the NVR. Share this post Link to post Share on other sites
SB_Jim 1 Posted June 14, 2013 Well, it could be helpful perhaps in saving time w/ trial & error. I've been fine-tuning my motion over the period of 1-2 weeks - finding the source of "non-productive" motion events by studying the motion events that were recorded during various time of day, lighting, wind, etc. But, other than that it appears to be more of a "frill" function. Share this post Link to post Share on other sites
apluspcnet 0 Posted June 14, 2013 Some vary know if Lorex NVR LDR200 Support Other brand of IP Camera, I need to add other camera to my NVR 8 POrt with 4 Cameras now and I order to Lorex but out stock from mid may and I need now Share this post Link to post Share on other sites
MaxIcon 0 Posted June 14, 2013 Blue Iris does this, and it's a huge help for setting up motion detect. Their motion detect settings are a lot more complex, though. Share this post Link to post Share on other sites
buellwinkle 0 Posted June 14, 2013 How do you know what the firmware version is on the Hikvision cameras? Mine doesn't have that option where it says Enable Dynamic Analysis for Motion Detection so not same release. Share this post Link to post Share on other sites
JoeyJoey 0 Posted June 14, 2013 It was v5.0 from the US Hikvision site. Raptor Firmware V5.0.0_130412 It mentions this in the manual. Share this post Link to post Share on other sites
