Joop1962 0 Posted May 3, 2015 You have to youse the TFTP recovery tool. just had the same problem, a few houres later i have it working again. ****, chinese on my camera.... lol, next problem.... there is NO reset button in the Hikvision DS-2CD2332-I turrent! i have it working again with the TFTP tool, now i have to put it back together. i unscrewed everything to search for a reset button. Share this post Link to post Share on other sites
RupertKent 0 Posted June 20, 2015 Hi guys. I'm new to the forum and have found this thread via Google as I had the exact same issue but I have now resolved it. My Hikvision DS-2CD2032-I has been working perfectly for around 12 months now on HTTP port 8008 but last night it stopped responding to everything and a ping of the camera was intermittent (I got several good pings then it would stop responding then come back etc.) I couldn't get access to the camera via HTTP, HTTPS, RTSP, nothing. I reset the camera and went back in via the default IP on Port 80. No problem. Change the port to 8008 and it stops. This happened several times. To cut a long story short, it seems my ISP (Sky in the UK) has upgraded the firmware in my ADSL 2+ modem router overnight and has added new features, one of which is WAN and LAN side IPv6 which was enabled. I disabled IPv6 and the camera now works perfectly again on 8008. Hope this helps you guys. Cheers, Rup Share this post Link to post Share on other sites
normel 0 Posted September 25, 2015 I dont think it has something to do with isp. I too, have installed 4 cameras 2032 model, and changed http ports, because 81,82,83,84 etc. now i cannot acces some, but i can ping them. Already tried with 192.168.1.82:82 but no.. nothing Share this post Link to post Share on other sites
normel 0 Posted September 30, 2015 uninstalling, and then reinstall together with winpcap fixed it for me Share this post Link to post Share on other sites
