jugalk1111 0 Posted June 15, 2014 How to configure Internet is working well on tplink hotspot. 1st DVR - online viewing is working well (DMZ on 192.168.1.1) 2nd DVR - when i open URL , page redirects to Dlink 2750u modem configuration page. Share this post Link to post Share on other sites
jamesmcuk 0 Posted June 19, 2014 I think you should make the hotspot and and extender use the same IP address range and SSID and Passcode as the main Dlink router. This should give you seemlees connection over all wifi. Then set you two DVR's to separate IP addresses on the last segment. E.g. 192.68.1.199 and .200 NB: You need to turn off DHCP on the Hotspot Also I would take the dvr out of the DMZ and change the DVR's web port to a number of your choosing rather than 80. So for example you may set DVR 1 to port 3636 and DVR 2 to 3737. Then when you are out of the house you can use a Dynamic IP Service like no-ip.com to access both DVR's via either yourrouterip.no-ip.com:3636 or yourrouterip.no-ip.com:3737 Share this post Link to post Share on other sites
Samir 0 Posted June 28, 2014 Dlink uses the 192.168.0.x subnet on a lot of their products for the configuration or default subnet. Change your other subnet addressing to 192.168.2.x and the problem will go away. Share this post Link to post Share on other sites
