oneeyebear 0 Posted January 9, 2015 I have an issue with my new Swann system. One of the cameras flickers/flashes at night when the ir is active. The strange thing to me is that the problem completely stops when there is motion present. I do not have motion alarming active on this camera. I have so far tried to correct the issue by restarting the camera. Also tried unplugging all other cameras and even changed power source locations. Any suggestions for this? Share this post Link to post Share on other sites
Excalibur 0 Posted January 9, 2015 Perhaps swap one of the other properly working cameras to the site of the problem camera. Then put that camera at the site of the 1st. Does the problem move with the camera ? or does it stay at the site of the original problem? Doing this could start narrowing down the possibilities and hopefully point to whether the problem is (camera)hardware, software or environment. Hope this helps. Sorry if it's a pain to do. Really, I'm not a cctv expert, I'm battling with my own problem.. Good luck. Share this post Link to post Share on other sites
