Jump to content
alexf40

Hikvision camera recording when movement out of frame

Recommended Posts

Hi,

 

I've setup my Hikvision cameras directly through the camera IP. I set the movement detection by drawing the grid.

 

However the snapshot is firing when movement is detected outside of the grid?

 

Any ideas would be most appreciated.

 

Cheers

Alex

Share this post


Link to post
Share on other sites

Hi. You will need to take into account pre and post recordings.

 

It works well when recording I.e 5 seconds before and 5 seconds after event will also be added to recording.

 

Sounds like you are only using snap shot

 

So you will need to set pre alarm to 0. (Factory set to 5)

Share this post


Link to post
Share on other sites

Hi Tom,

 

Thanks for the reply. I am using the 5 second pre-record feature, but this isn't the issue, any movement which is outside of the selected movement detection grid is setting off the motion detection. Is there any other setting which I may have incorrect?

 

In regards to the snapshot feature, I'm using an app called Cammy which I FTP the snapshots to, this allows me to have very simple off site recordings and they also have an alarm system.

 

I still backup locally to the Hikvision NVR.

 

Cheers

Alex

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×