tomcctv

Just sounds like your on your local network .... Don't need port forward to have that working As far as 3G depends on your phone If it works local it will work on 3G What ports did you open

Would help if you could read first problem solved Two posts up is a new problem And again he will get help it's not a joke it's called HELP

Hi. Can you tell us a little about your router And if you can get local connection to dvr

Hi think you might have a differant raysharp Avtech was also sold under that name Can you post a picture of front of your dvr

Don't see we're a jury comes into it Before it gets to court it is first desided if any wrong doing has taken place which is when cctv (information collection) shows it has. So long as shop or office has all the licence to collect information from its cctv

Hi ... How have you connected the control If direct to nvr then under settings for prz you have a drop down box pick local in to nvr if into switch or router select remote

Hi yes you get both units in one box

Hi yes set of these will do what you need. Buy from local store and don't buy cheap no name units http://www.netgear.com/home/products/networking/powerline/XAVB5602.aspx

Hi. Rory is the guy you need to talk to he has spent a lot of time with work around for both geo and dahua over the years He put together so good software Email in your pm box

Only thing that stands out are the COUPLERS. always best for cat cable to be one run

Hi. If it's only a cable problem you have .... Might look at putting upto 8 cameras down one existing coax

If you changed codes then switch dvr off for 20 minutes If you enter code wrong or too many times then it will not allow you in....... This is why 000000 did not work for you But use the code in PM

Did you restart your dvr then try your passwords But new code 331840

Do Admin 148648 Or Gezer 148648

Pm is personal message which is top right of page

Try the code that is in your PM

That date is 000000

Admin and password blank

Admin and password blank Or admin and change numbers to letters in drop down box and admin admin

Have you entered code into dvr

Listen read post your code did not work for him Also code generator for that dvr has two ways to check

Sorry, i mean date time in your DVR. admin and gereate password at this date on your DVR can help you. I already gave you password at 2014-08-14 for the admin account. What is your DVR time date? 776384 -is wrond generate password at 2014-08-14!!! 776384 is not wrong password at all

Hi. If you have a gezer as password it's not brand new or it's demo But admin and 776384 will get you in

776384

Hi. Bit hard to answer ...... What system are you installing to make your customer think your expensive You listed the swann. Which system are you installing