Jump to content

Giovanni77

Members
 View Profile  See their activity

  • Content Count

    5

  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Giovanni77
    I understand that it is hard to believe but I have tried to connect the ip cameras to the local network with metric 192.168.0.x but in this case the ip camera does not acquire any ip and I cannot find it on the network. I then changed my network metrics by setting 192.168.1.x and in this way the ip camera acquires address 192.168.1.251 and I can therefore see it. I also tried to set the rule in the router via the mac address of the ip camera but it fails. I repeat that the camera has memorized this damn address and there is no way to change it. I need to reset.
  2. Giovanni77
    I tried to do what you write but the ip cameras have the ip blocked and do not acquire any other value. I also tried to change it with Onvif Device Manager but it gets an error when I try to change the configuration. I think that for some reason the ip cameras have been locked perhaps with a password.
  3. Giovanni77
    Maybe I can't explain well. All the ip cams connected to the NVR have acquired the same IP (192.168.1.251) and there is no way to modify it. This means that the NVR is now able to display only one connected camera since the second would look for the same address. All the IP cameras have memorized this same IP and it is not possible to change it even by setting DHCP. This is why I wonder if it is possible that the cameras have acquired a setting and need a factory reset.
  4. Giovanni77
    Exploring the local network I can find the IP Cam and I can also see the images using an Onvif viewer. But unfortunately the IP Cam keeps a static IP address 192.168.1.251 and there is no way to change it. Perhaps a password has been set in the configuration. For this reason I assumed that a factory reset was absolutely necessary.
  5. Giovanni77 started following Impossible factory reset POE camera
  6. Giovanni77
    Hello everyone and thank you for welcoming me to the forum. I would like to ask those more experienced than me if there is a way to do the factory reset for this IP cam in the picture. Unfortunately, the manufacturer's software that perhaps could have been used is no longer available on the internet (this was the original link no longer available "www.amosec.com/ocx/ipcconfig.exe"). I searched for an internal hard reset button with no success. Anyone familiar with this PCB and what are the pins to use for hard reset? In your opinion, is there any other solution? Thank you all
×