Jump to content
Sign in to follow this  
ant200

help with ptz

Recommended Posts

hi all i have a panasonic wv-cs580g cani use my  iapollo hdrt lite dvr to control it thanks

Share this post


Link to post
Share on other sites

Hi. How do you have it connected to your dvr .  ......

that unit has rs485 plus terminals A &B 

 

it it is A &. b you need to control 

Share this post


Link to post
Share on other sites

Ok. So what are the protocols on the camera and the dvr 

you should see PTZ on your monitor when you power down then back on

Share this post


Link to post
Share on other sites

hi no just dont do nothing picture but no movment

set dvr as pelco d and dip switches set as same as  book says pelco d and yes still nothing 

Share this post


Link to post
Share on other sites
4 minutes ago, ant200 said:

would i need a joystick control aswell thanks

 

No joystick needed with building rs485 

address .......01 

protocol ......Pelco d 

baud rate ........2400

 

set on both your camer and dvr

 

on your dvr .... Hit menu at bottom and I think PTZ settings are second down on left of window

 

 

 

 

Share this post


Link to post
Share on other sites

Hi Tom the 485 plug has 4 wires in 2 tx 2 rx cut plug off as only use the two  that goes two   A B

address 1

protocol pelco d

baudrate  9600

Data bits 8

Stop bits 1

Parity none

set both cam and dvr 

To this and got nothing

     Thaks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×