Jump to content
Sign in to follow this  

Questions about Installation (ACM8 board)

Recommended Posts

We are working with a Genetec controlled systems using Mercury boards. (LP1502 and MR52) with 24v power supply controlled by an ACM8 board powering fail safe electronic locks. My question is what would be the correct method of installation. Wiring the output relays from the LP1502 to the ACM8 as normally open as well as terminating the electronic locks on the ACM8 board as normally open. Or, the output relays as normally closed and the electronic locks as normally closed, constantly triggering the relay on the ACM8 board until someone badges in to kill power. I am somewhat new to access control and although both methods work what is the proper installation. I was corrected from using the former method to the latter. Which caused confusion in my understanding. if someone could provide any knowledge on this it would be greatly appreciated. I am young tech trying to learn the proper installation methods without guidance of someone with experience in this area. Thank you.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this