G22 0 Posted April 18, 2008 I can't get the 3 screws off this Panasonic WV-CW474AS dome cam. It appears to be a torx head, but there is also a center piece protruding in the middle. Would seem the torx head would need to be hollow also. Is there some special tool needed? The last WV-CW474AS I had no probs getting it off and do not recall that center piece. Thx. Share this post Link to post Share on other sites
CCTV_Suppliers 0 Posted April 18, 2008 Nothing special about the tool... go to Home Depot and they have them... Share this post Link to post Share on other sites
G22 0 Posted April 18, 2008 Are you sure? This center piece almost seems flush with the top. Share this post Link to post Share on other sites
survtech 0 Posted April 18, 2008 Didn't Panasonic include a tool or bit? It sounds like a Torx security bit. See below: You can get the tool many places, including MCM Electronics: http://www.mcmelectronics.com/product/22-9795 Share this post Link to post Share on other sites
G22 0 Posted April 18, 2008 Yep, it needed a Torx security bit. I found a complete set today at a local electronics store. The camera did not come with one. It was off feebay. Thx. Share this post Link to post Share on other sites
