PAL to NTSC

[vector18 1]

Has anyone converted a Dahua pal dvr to ntsc? If so, how did you do it and can you email me the firmware? Thanks.

[tomcctv 187]

No it can't be done on there DVRs. It's the board that has the region not the software

[vector18 1]

Do you know this for a fact? I was told different.

[tomcctv 187]

Do you know this for a fact? I was told different.

 

 

 

if you take a look at the ftp site it tells you how.

 

what you have to remember is firmware is not the OS it is just for adding fix patches for bugs.

 

you can only use PAL firmware for PAL or NTSC for NTSC or it will just hang

 

 

if you look on serial plate you should see PAL or NTSC and some even have SECOM this is its OS for its region.

 

you can get a region flash from there FTP but it take a few hours and even then that has problems .

 

 

some dahua do and can run in either no firmware needed its tick box on first startup or in menu

[vector18 1]

anyone wanna buy a PAL 8 channel dahua? lol

[coolie11 0]

This is a good topic to research.

My reason is that I have installed PAL Firmware to there IP Cams which was originally NTSC and then back.

[coolie11 0]

Do you know this for a fact? I was told different.

 

 

 

if you take a look at the ftp site it tells you how.

 

what you have to remember is firmware is not the OS it is just for adding fix patches for bugs.

 

you can only use PAL firmware for PAL or NTSC for NTSC or it will just hang

 

 

if you look on serial plate you should see PAL or NTSC and some even have SECOM this is its OS for its region.

 

you can get a region flash from there FTP but it take a few hours and even then that has problems .

 

 

some dahua do and can run in either no firmware needed its tick box on first startup or in menu

 

"if you take a look at the ftp site"?