Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation since 02/05/2019 in all areas

  1. 2 points
    Hi. No don’t update Remove your no ip account Your using the Apollo ... good system Delete your no ip and follow the link I have sent to your PM Much more secure and protected
  2. 1 point
    I bought Dahua DH-IPC-HFW1320S IP camera on eBay, and I have problem setting up FTP upload of recordings to FTP server. Here are my settings: For remote directory I used "/", "/test", "test" or leave blank and results are always same. This log entries shows that motion detection was triggered For first I used ftp server on internet, later I started filezilla ftp server on my pc. This is log form FileZilla FTP server. (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> Connected on port 21, sending welcome message... (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 220-FileZilla Server 0.9.60 beta (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 220-written by Tim Kosse (tim.kosse@filezilla-project.org) (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 220 Please visit https://filezilla-project.org/ (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> USER test (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 331 Password required for test (000010)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> PASS **** (000010)10.2.2017 3:32:07 - test (192.168.251.213)> 230 Logged on (000010)10.2.2017 3:32:07 - test (192.168.251.213)> PWD (000010)10.2.2017 3:32:07 - test (192.168.251.213)> 257 "/" is current directory. (000010)10.2.2017 3:32:07 - test (192.168.251.213)> disconnected. (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> Connected on port 21, sending welcome message... (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 220-FileZilla Server 0.9.60 beta (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 220-written by Tim Kosse (tim.kosse@filezilla-project.org) (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 220 Please visit https://filezilla-project.org/ (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> USER test (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> 331 Password required for test (000011)10.2.2017 3:32:07 - (not logged in) (192.168.251.213)> PASS **** (000011)10.2.2017 3:32:07 - test (192.168.251.213)> 230 Logged on (000011)10.2.2017 3:32:07 - test (192.168.251.213)> PWD (000011)10.2.2017 3:32:07 - test (192.168.251.213)> 257 "/" is current directory. (000011)10.2.2017 3:32:07 - test (192.168.251.213)> QUIT (000011)10.2.2017 3:32:07 - test (192.168.251.213)> 221 Goodbye (000011)10.2.2017 3:32:07 - test (192.168.251.213)> disconnected. So, communication is ok, camera can access and login to ftp server, but why that camera wont upload anything? I also tested NAS as storage, and everything that I got is that camera can create folder on NAS. What can be wrong here?
  3. 1 point
    Hi Folks, I forgot admin password of Hikvision dvr. Could anybody please help me with this I am using Hikvision 2 series DVR. Thanks
  4. 1 point
    Hello I bought a model VTO2000A Videophone intercom. I accidentally Entered the wrong password three times. Unfortunately I can not get in because i scive blocked user. How can I return to factory reset? very kind people who want to help thank you
  5. 1 point
    anyone here can give me an advise on protecting CCTV cameras from lightning? How to make a proper earth gorunding?
  6. 1 point
    hd908 seems too relaxed to be boogerman/fenderman.
  7. 1 point
    I'm sorry, alpalp, but I do not have a recommendation for you. Some of the more experienced guys here I'm certain might have. A lot of people like BI. Maybe it's great. But I don't trust MS-Windows any further than I can spit, so I'll never know. If one of the Linux flavours is your thing, possibly Blue Cherry DVR? I may give that a go if things don't work out with Synology.
  8. 1 point
    You're welcome. As for Blue Iris: I can't help you. I try to avoid MS-Windows. As for the "other forum": If it's the forum I think it is you'll notice they sell BI
  9. 1 point
    You will need to with blue iris there is a fee for both blue iris and using there app how many cameras are you looking for
  10. 1 point
    First question: What are you trying to achieve? That will determine what kind of cameras you need and how many. Second question: Is there a particular reason you want an analog system, as opposed to IP cameras? Third question: What do you consider to be "average cost?"
  11. 1 point
    Yes that's right what will you be using the system for ...home or business use ?
  12. 1 point
    Hi. No need to take anything down .....your network is only used for remote viewing with only using two 5mp your ok but I would look at adding later 4mp and even 2mp is small areas or you will need to drop FPS also remember you can use any tvi camera or 4 in 1 camera does not need to be hikvision if you have not bought anything yet I would pic TVT over hikvision security industry had another report yesterday on hik hack
  13. 1 point
    There are two ways to go about this: Find the output current rating on the power supply (I assume the Lorex NVR powers the cameras?) and multiply that by its output voltage. That will give you its approximate max wattage. UPS' are rated in VA (volt-amps), but it'll be close enough. The other way is to actually measure the current draw on the AC side using a true RMS ammeter. (That's the best way.) Then multiply the measured current draw times the line voltage. Next you have to determine whether the point is to protect your surveillance system and allow it to survive short-term outages, or to have it stay up for an extended time when there's an outage. (I note you list a "12V 10" PSU. If that's 12V at 10A, which would probably be about right for an 8-camera system [assuming about 15W/camera], then your want a minimum 120VA UPS. Depending upon the design, that may give you anywhere from 5-10 minutes of uptime [SWAG]). To a degree you can extend uptime by going with a higher-than-recommend-VA UPS, but there are diminishing returns with each bump in VA capacity. Reason is reduced efficiencies as UPS VA capacity goes up. For truly extended runtime you need an "extended runtime" UPS. They don't have greater VA capacity, but more battery. (They also take longer to recover because there's more battery capacity to charge back up. There ain't no free lunches.) E.g.: With a 120W load, a 120VA UPS may give you about 5-10 minutes of uptime, but a 360VA UPS won't necessarily give you 15-30 minutes. In fact: My old power-hog Dell 1600SC server had a 700VA APC SmartUPS on it. The computer + peripherals drew about 200W. The UPS had a runtime of only fifteen minutes with brand new batteries. Speaking of batteries: Make sure to buy a UPS with user-replaceable batteries. They have about a three-year lifespan. Also: Get in the habit of doing run-time tests about every quarter or so, to extend battery life. The UPS manufacturer should have a chart listing estimated run times for each of their UPS' vs. expected loads.
  14. 1 point
    Hi there, I just want to inform you in my case I do not receive anymore the notifications on my mobile phone (gDMSS Plus) when someone rings on the door. It looks to be a general issue Dahua must solve after Google has changed the push service , see reply from my vendor : This afternoon it has been revealed that Google has changed the push service for a number of Android versions and this has impact on a large part of the Android devices using IMOU or GDMSS. This implies that Dahua must solve it, just Dahua is currently celebrating Chinese New Year, which makes the solution just waiting a bit longer. Hope it can help you if you are in the same situation.
  15. 1 point
    No .... if you come on with camera awful then there has to be a reason. calibrating is done on the camera ... it’s done while installing does zoneminder do 4k yet ? does it do h265 ? RTSP ..... I think you will find onvif is the best way explain why you should defend h264 ? Are you using 4k Why ..... because you don’t like to hear that your cameras are not compatible with what you using with them. So your expecting 8mp/4k on equipment that can’t get you there You will need to load software for cam onto pc then go into settings .....being on zoneminder I would also drop resolution down to 4mp .... not 8. Then go into camera zoom and move far out then in and then set it to distance needed then click save
  16. 1 point
    Boogieman, this is Dahua , not Hikvision! I suggest upgrading firmware to the latest version, setting strong passwords (mix uppercase and lowercase letters, numbers and special characters) and changing ports. Works on Hikvision, hope it works on Dahua too. This happens on systems running with default passwords and ports, no special backdoor needed. Newer versions of Hikvision firmwares do not allow simple passwords, and that's it.
  17. 1 point
    Hi. Rain or snow does not have to have contact with sensor. .... so just sensor under cover will not help I would forget trying to get a pir sensor to work at that distance. I would look at GJD wireless pir heads. Very reliable and last 4 years on one 9v standard battery Mount pir at your gate ..... set detection patern..... also control on and off and schedule from recorder http://www.gjd.co.uk/products/wireless-detectors
  18. 1 point
    Cheers Tomcctv much appreciated I use no-ip and set it up myself Someone advised I set up a vpn but don't know how much money and effort required. Do i need to update firmware on cameras as well as the apollo?
  19. 1 point
    Hi. You only need to forward port 37777 and don’t portforward anything else. Also reload your app as another was released Thursday It does not matter re doing ports of passwords if you don’t also change your IP address. If you want someone to phone you at home you give them your telephone number It’s the same with your IP address it’s like the telephone to your Network once someone has it they can use it. A full router reset is also a good idea Which ddns service did you use ...... did you set it up ? Also check your PM I have sent you a message and you need to act on it
  20. 1 point
    Problem solved! The daughter bought the same style camera with WiFi and her new boyfriend put up a pole made out of 1 3/4" plastic pipe. He mounted the camera to treated wood and attached it to the pole and placed it right next to the neighbor's camera but in my yard. Now she can't see his camera from the window and she has a great view of his rear patio. Haven't heard a peep from him yet. Nothing illegal and nobody got hurt!
  21. 1 point
    I would also think anyone who owned a home .... would like to OWN there home Boarding up windows ..... who in there right mind would do that to there home. Turning home into a windowless box. Guy has admitted to being able to see into the bed room...... so he is already watching...... even the guy admitting it is a problem in it's self
  22. 1 point
    The problem with that is he can also switch it on and off when he likes
  23. 1 point
    Just put here full boot log!
  24. 1 point
  25. 1 point
    I Seen this nasty mess today............. Oh wait a minute, this is my system
This leaderboard is set to Chicago/GMT-05:00
×